Well location: The system used for locating wells is based on the rectangular system for subdivision 
    of public land. The State is divided into 36 square mile townships numbered according to their 
    location relative to the east-west Willamette baseline and a north-south Willamette meridian. The 
    position of a township is given by its north-south "Township" position relative to the baseline 
    and its east-west "Range" position relative to the meridian. Each township is divided into 
    36 sections approximately 1-square-mile (640-acre) in area and numbered from 1 to 36. For example, 
    a well designated as 01S/03E-33DCA is located in Township 1 south, Range 3 east, section 33. The 
    letters following the section number correspond to the location within the section; the first 
    letter (D) identifies the quarter section (160 acres); the second letter (C) identifies the 
    quarter-quarter section (40 acres); and the third letter (A) identifies the quarter-quarter-quarter 
    section (10 acres). Thus, well 33DCA is located in the NE quarter of the SW quarter of the SE quarter
    of section 33. Sorted on this item.
Well Log ID: Unique identifier combining a four-letter county-code and a well-log number with up  
    to 6 digits, which is assigned to the well when a water well report is filed by the 
    well driller with the Oregon Water Resources Department and recorded in  
    Ground Water Resource Information Distribution (GRID), a statewide computer database 
    maintained by Oregon Water Resources Department. 
USGS Site ID: Site identification number permanently assigned to the well by the U.S. Geological  
    Survey and recorded in National Water Information System (NWIS), a national computer 
    database maintained by U.S. Geological Survey.
Water level: Static water level, in feet below land surface, - indicates water level above land surface.
Measuring status: The status of the site at the time the water level was measured;
    D, the site was dry (no water level is recorded); 
    E, the site was flowing recently;  
    F, the site was flowing; 
    G, a nearby site was flowing; 
    H, A nearby site that taps the same aquifer had been flowing recently;
    I, injector site (recharge water being injected into the aquifer);
    P, the site was being pumped; 
    R, the site was pumped recently; 
    S, a nearby site was being pumped;
    T, a nearby site had been pumped recently; 
    V, foreign substance was present on the surface of the water;
    W, the well was destroyed;
    Z, other conditions.
Measuring method: 
    A, Airline measurement; 
    B, Analog, graphic, or digital recorder; 
    C, Calibrated airline measurement; 
    E, estimated; 
    G, Pressure-gage measurement; 
    H, Calibrated pressure-gage measurement; 
    M, Manometer measurement; 
    R, Reported, method not known (generally by driller); 
    S, Steel-tape measurement;
    T, Electic-tape measurement; 
    V, Calibrated electic-tape measurement; 
    Z, Other.
--, no  data.